Use this workflow to connect the LytxOne Gateway (LX1-G) to a Volvo truck using the Volvo cable (HCA-VICVO-01). This cable has a Molex connector on one end for the Gateway, and a vehicle-specific pigtail on the other end that connects directly to the truck's factory connector, no add-a-fuse adapter is used, since these vehicles use a different power distribution system than standard fuse boxes.
What You Will Need
- LytxOne Gateway
- Volvo cable (HCA-VICVO-01)
- Multimeter (recommended, not included)
HCA-VICM2-01 Cable Components
| Component |
Description |
| Vehicle-specific pigtail |
Connects directly to the Volvo's factory connector |
| Molex connector |
Connects to the PWR/OBD port on the LytxOne Gateway |
Note
On Volvo trucks, the factory connector is typically located at the top of the dashboard, near the fuse box. Location can vary by model year, use a multimeter to confirm power and ground before connecting.
Connect the Cable
- With the engine off, locate the vehicle's factory connector at the top of the dashboard, near the fuse box.
- Use a multimeter to confirm constant 12V power and a stable ground are present at the connector.
- Connect the pigtail to the vehicle's factory connector.
- Confirm the cable is clear of the vehicle's pedals, steering linkage, and other moving parts. Physically operate all pedals through their full range of motion to check.
- Connect the Molex connector to the PWR/OBD port on the LytxOne Gateway.
- Mount the Gateway in a safe, hidden location, avoiding areas that may heat up or shift while driving.
To finish the installation, continue to Step 3: Mount & Wire to secure the Gateway and mount the Camera, then Step 4: Activate, Verify, Complete to activate and verify the installation.
Safety Notice
Before installing or operating this device, read the full Safety and Maintenance Guidelines.